Traits

Serpent tail is a strange trait in that the tail behaves like a living snake but is entirely made from the mhoat's own goo. This tail may take the form of any type of snake, from viper, garden snake, and even cobras.

Aquatics with this trait have a thick, sturdy tail covered in thick plating and ends in a thick, fanned tail.

Mhoats with this trait form a long, prehensile tail that has a lantern-like section made of goo at the tip. The lantern can have a variety of appearances and has a concentrated level of bioluminescence, which means it gives off noticeable light even during the day.

This tail type can either match the example shown or be any number of stylized and layered fins. These fins can be both at the end of the tail or along the entire length of it, how they are applied is entirely up to the creative choices of the artist designing the mhoat. This tail type tends to be more elegant and showy, tails mimicking various types of flowers being fairly common.

This tail type allows the mhoat to have a set of up to 8 tentacles that resemble an octopus' legs. Unlike other tails, you may only combine this trait with the multiple tails trait once for a total of 12 tails allowed on a design.

Aquatics with this tail type form a variety of fish-like tails.

Mhoats with this tail trait form a ribbon-like tail that can be tied into various styles of bows.

Similar to a knotted tail, this trait allows for a prehensile tail that mimics a string of lights. The lights on the tail may break the rules for total goo colors present.

This tail type allows the mhoat to have a set of up to 8 tentacles that resemble an octopus' legs. Unlike other tails, you may only combine this trait with the multiple tails trait once for a total of 12 tails allowed on a design.

This tail behaves like water and has small white patches that mimic sea foam, the tail disappears while in water.

Aquatics with this tail form a wide, flat tail that resembles those seen on various whales and dolphins and is oriented horizontally rather than vertically much like the animals this tail type is based on.

Mhoats with this tail type form a tail that resembles a stingray with a long, whip-like tail that forms two pairs of fins, a large and smaller set along its length.

Mhoats with this tail type form an additional pair of wings in place of the tail. These wings can mimic any standard or mutation rarity wing found in the Mhoat Wings category.

This tail type is retractable, meaning the mhoat can pull it into the body and leave just the mushroom cap showing when it wants to have a little bobtail. The tip of this tail tends to have plating on it, which follows the body colors but this is not mandatory detail.

Mhoats with this trait have a long whip-like tail with numerous sets of small wings along its length. Longer tails tend to have more wings present and these wings can resemble any standard rarity wing seen under the Mhoat Wings category, while higher rarities will be dependent upon those wings being present on the design or being combined with other tail traits.

Mhoats with this trait form fish-like tails with a variety of fin shapes.

Mhoats with this trait form a tail that has a skeletal appearance.

This long, prehensile tail type can be controlled by the mhoat that has it, those with skill being able to form them into little knots and intricate woven designs when not kept loose.

Mhoats with this trait form a long slender tail with little leaf-like spikes that mimic a vine.

This long slender tail forms a wide fan of shaped extensions at the tip that often resemble a fan and can be spread or narrowed down which the mhoat can control.